View RSS Feed

DIY projects

Do It Yourself projects

  1. Greener use of waste water

    This is one of those projects I've thought about for some time, but finally got outdoors and implemented it. I wanted to see how this works, and will clean it up after I've had a little time to work out any kinks in the execution.

    Categories
    DIY projects
  2. Overflow covered from the lights

    Over the past two months, I've watched algae grow in the overflow. Since it is lit from the metal halides above, a cover was needed. Now that the fifth and final Durso was installed, the cover could be fabricated and placed over that area.

    I decided to make the cover big enough to cover the entire external overflow and overhang the teeth a little. It had to be drilled for the Durso caps, as well as for the Aqua Controller probes.

    Top side
    ...
    Categories
    Tank Entry , ‎ DIY projects
  3. The weather broke for a day, and I seized the moment to paint

    I've been wanting to paint the fishroom floor for over two months, but never had the right conditions. Yesterday, the weather was 64F for the high compared to the day before when it was 85F. I pulled out everything scattered around the fishroom floor, grabbed the air hose from my compressor and blasted dust everywhere, swept up the mess and damp mopped the concrete to get rid of any other dust.

    Btw, that cloud was ominous and a lot of it settled on the surface of the reef. Not exactly ...
  4. Fishroom Vent Fan

    To keep humidity levels down in the fishroom, it's important to have a vent fan that exports moist air out of the home. With my last tank, humidity was a factor but once the vent was installed, a marked improvement occurred. During the remodeling project, I tried to clean up the old fan but it had shorted out, leaving a dead motor in its wake.

    When the 280g was running, the vent was directly over the tank. I felt that was the perfect spot because it would exhaust heat from the ...
    Tags: vent fan
    Categories
    DIY projects
  5. Small modifications make good solutions

    Over the past couple of weeks, little changes were made to adjust circumstances that resulted in better conditions with the 400g.

    1) The water line was just under the plastic trim of the tank. I don't like that look since it usually cause "light leak" into the room. Rather than having to look at that beam of light, I prefer to raise the water level in the display tank. Taking a scrap of 3/8" acrylic, I placed it in the overflow behind the teeth and this increased the height of ...

    Updated 02-18-2011 at 10:31 AM by melev

    Categories
    DIY projects
Page 3 of 7 FirstFirst 12345 ... LastLast