View RSS Feed

Tyron

Need acrylic advice.

Rate this Entry
So i tried emailing melev but i figure he was busy. I need advice from someone who works with acrylic often, or is very knowledgeable about tank building. My question is I want to build a tank. The dimensions are 24x24x12 inches (approx 30g). If i want it to be rimless, will 3/8in be fine? I asked a few other people and answers varied. Thnx guys

Submit "Need acrylic advice." to Digg Submit "Need acrylic advice." to del.icio.us Submit "Need acrylic advice." to StumbleUpon Submit "Need acrylic advice." to Google

Comments

  1. DJ in WV's Avatar
    at 12" high 3/8" in a cell cast will be fine imo, if money isnt a big factor then 1/2 will have a higher safety factor and less deflection. Make sure you get cellcast though. The rimless feature is why you are getting mixed answers. Most also recommend using a 2 part instead of a solvent for assemble which I would say is a good Idea on a rimless build something like weldon 40
  2. Midnight's Avatar
    Yes 3/8 is fine for 12" high rimless. the seems will be fine with weldon 3/4. Horizontal bowing is the only factor affected by the rimless feature.
  3. Tyron's Avatar
    So I'm still going to experience some horizontal bowing if i choose 3/8. I think if I have to go with 1/2 then ill make it a little taller. Maybe 15inches
  4. Midnight's Avatar
    At only two feet long I don't thing you will see any bowing with 3/8 cell cast