The first photo is of the center divider (for the cabinet attached to the back panel) and the bulkhead panel (for the conduit from the front electronics compartment in the stand). As with the other areas of this project the white painted areas is for the wet area and the black painted areas is for the electronics. The front electronics area is for the sensor modules and the back cabinet is for the power bars and various power supplies. The center divider has inserts to install up to two 4 channel ...
The second photo is of the parts for top of the back cover for mouting the exhaust fans for the wet area. The fans are shown with the rest of the parts. This will have some modifications on the final assembly, but mostly minor..The first and third photos are of the top frame assebly for the back cover. The corners had to be notched to clear the sides of the back panel on the canopy. The last three photos are of the back cover assembled. As noted earlier the back will not have a panel the top and ...
Updated 07-19-2015 at 09:36 PM by n2585722
The first two photos are the parts of the sides to the back cover. The third photo is of the parts to the back of the back cover. This has been changed since the photo. It now has a solid back. I was going to put a panel in and decided that would not work water from spills that would get in the panel slots of the rails and stiles. I figured that would not be good in the long run and changed it. I don't have a photo of the parts for the back after the change. The forth photo is of the sides and back ...
Updated 07-14-2015 at 07:01 AM by n2585722
The first photo is of the parts to the bottom outer frame. The second photo is the parts for the top outer frame. The third photo is the top side of the bottom outer frame assembled. The forth photo is of the bottom of the bottom outer frame assembled. The bottom outer frame is attached to the base of the inner frame with 12 pocket hole screws. There was a strip of 1x2 added in the back after the photo was taken to allow the electrical boxes to be screwed to the bottom frame inside the back cabinet. ...
The first photo is of one of the back cabinet door's parts. The door was too narrow to have a raised panel so it is a standard panel. There are two doors one on each side. The next three photos are of the parts for the back cabinet that is attached to the back panel. The back panel is the same as the side panels with the exception it has no air vent at the bottom. The fifth photo is the center partition inside the cabinet. This is where the power bars for the controller will be mounted. The partition ...
Recent Comments
