The first photo is the top inner frame parts of the stand. It has been notched with the router for the six post. The inner sides of the post have been trimmed to make room for a wider sump. It can be placed in either of two positions. To do this two of the post had to be trimmed on both sides. The parts stacked to the right in the photo are for the bottom frame. The next two photos are of the top frame one of each side. The next photo is of the bottom inner frame parts of the stand. You can see ...
I've been reefkeeping for about 25 years, and in that time I've gone from a 20 long, a 45 tall, and now a 135. When I got the larger tank (for a steal), I was super excited. I finely had the size I wanted. Large enough without being too large. Or so I thought. The tank has been up for about 6 years. In that time I've slowly lost interest. It seems I've put tons of time and money into care and maintenance, and very little time stopping and enjoying the tank. So, much to my wife's delight, I ...
Below are photo's of the parts for the stand. It is similar to the canopy in that has a inner frame which is actually the stand holding the tank. The back panel is a cabinet with 2 doors. One on each side. This will house the power bars for the pumps and other devices. It will also house the power supply's for the LED's. Behind the front door of the Stand will be the controller and modules. There are two doors on each side to gain access under the stand.
Updated 07-05-2015 at 07:30 AM by n2585722
Recent Comments
