When I had the back cabinet off I decided to change up a few things including mounting the outlet boxes in the cabinet assembly instead of on the bottom outer frame assembly (first two photos). I also set them at a 15 degree angle to make it a little easier to plug things in and out. I kept tripping the GFI breaker with my fingers when it was mounted on the outer frame. The wires in the second photo going in the hole were placed there just to get them out of the way for the photo. These photos were ...
Updated 08-17-2015 at 06:31 AM by n2585722
New video posted on the melevsreef youtube channel. This just gives you about five minutes' to view my reeflings.
The reef continues to do well. I mentioned on the first what I'd done for the reef. I treated the tank with Phosphate Rx to knock down PO4, and have pretty much only kept up with wiping the glass down every couple of days. The CO2 tank ran dry so last Friday I refilled it at the liquor store, which maintains the lower pH in the calcium reactor around the clock. I'm keeping that level at 7.0 to dissolve the media gradually. Here are a few pictures. Note the clarity of the water ...
The first photo is of the top outer frame assembly complete(top view). Around the white area is trim with the top at a 15 degree down angle to keep any splashed water in the white area. The back cover also has matching trim that ovelaps this trim so any water that is dripping down the side of the back cover will remain in the white area. The second photo of the top frame assembly complete(bottom view) shows the router pattern to allow the frame to cover the top of the side panels and back cabinet ...
Updated 08-10-2015 at 10:24 AM by n2585722
The first 2 photos are of the diverter used to channel any water spilled at the back of the tank to the stand. The third photo is of the diverter in place without the trim around the top. this view is from the top of the cabinet. The forth photo is from the top with the trim glued in place. The top outer frame assembly also has trim in place to channel the spilled water into this diverter. The last photo is a view from the stand side of the back cabinet. Please excuse it being sideways. I tried ...
Recent Comments
