View RSS Feed

chbix

Power outtage?

Rate this Entry
2 Comments
by
chbix
, 12-11-2012 at 09:13 PM (2386 Views)
So I came home, and found my return pump sucking air and blowing it into the DT.

Open the cabinet doors to find the water level in the return area was low....
now I know the water level didnt evaporate that much as I added like 2-3 gallons of top off yesterday.I adjusted the return pump flow down to allow the water to catch back up and then was able to open the valve completely open again and things stabilized and no issues....I added another gallon of top off just to be safe...

I haven't had this issues with my new overflow box.

Looked at the microwave and stove and realized that the power had been out sometime during the day.

I have a power head hooked to the overflow via air hose to maintain siphon and kick start the siphon in case of a power outage...I have tested this multiple times and have had no issues....

I also looked at my AC3 and the display was changed (I keep it on the Temp and PH monitor screen) so I know the power went out.

Any ideas what went wrong? Anyone know why it doesn't list a power out on the AC3 iphone ap or when I log in via the web interface?

Positive note is that Ammonia is near zero (between .25 & .5 ppm) nitrites are up and I have started seeing Nitrates as well!!

Submit "Power outtage?" to Digg Submit "Power outtage?" to del.icio.us Submit "Power outtage?" to StumbleUpon Submit "Power outtage?" to Google

Categories
‎ Electrical , ‎ Plumbing , ‎ Questions - Need some input , ‎ Equipment

Comments

  1. melev's Avatar
    Where did the excess water go during the power outage? Is the carpet wet? If your return pump sucked air and pumped this into the display tank, the sump has less water. The overflow didn't fail, because the system resumed draining, correct?

    For the AC3 to report a power outage, it must be plugged into a UPS or have a 9v battery connected to allow it to store the power loss.
  2. chbix's Avatar
    I think the issue was two filter pads I have in the tank. I have them in the sump to gather bacteria for use in a QT tank...They slipped down into the bubble trap and I think they were blocking flow into the return pump chamber....Have to find a better place for these.