All Blog Entries

I tried to use a 2 ton jack to lift up that busy intersection of the trusses, but it didn't have the strength. I try again tomorrow with a bigger jack to raise that low spot up 1".

The 12' 2x4 was put in place next to the other rafter that appeared to be dipping, but with the new one next to it, the problem seemed unfounded. I may nail it on tomorrow anyway just to add a little strength since that one is running directly over the reef tank.

I decided to set up the Skimmer ...

So here it is, I had to take the 90g down and found a way to get this 45 corner up and running

http://www.youtube.com/watch?v=dPXqBS_TECY

First off I am no guru on skimmers like Luke33 is on other forums. However I do know a thing or 2 on what works for me. I started on this project with a Reef devil skimmer,It was a devil to setup and stabalize. I called it Satan. Anyhow I stuck with this for part of my process but eventually got my hands on turbo clone


Well I got my hands on turbo clone, but it needed work badly
But hey it was free, ...

Ok here we go.

Step one get yourself a container with screw on lid,, a 2 liter coke bottle will work to.

step 2. clean completely of labels and residue.

Step 3. Drill a hole in center of lid measuring 3/4 inch

Step 4 Pick up a Hose Barb from Home depot measuring 1/2 barb with 3/4 in male adapter

Step 5. Drill holes of 1/8 inch around the hose barb.

Step 6 Get yourself a little Maxi jet 90 pump.

Step 7 obtain ...

In my Previous blog I gave some of my background in tanks. Now it is time to get down to it. I scored a acrylic 55 gallon from a fellow club member here for 100.00 with stand and canopy. the tank was pretty rough, mico scratches all over and just looked bad over all. I gave it good cleaning and it came looking like this.

After much rubbing with Novus ( great stuff for acrylic owners) it came out lookiing like ...